31 GB/IE/NI
Point the sensor tip
towards the object or
the liquid to be meas-
ured (never immerse in
liquids!) at a distance of
3 cm and press the ON / OFF / MEASURE
button
8
for 1 second.
Release the
ON / OFF /
MEASURE
button
8
. The
measured value
appears on the display and the end of measure-
ment is indicated with a short beep (when the key
tone is activated). When the measurement type
symbol stops flashing, the next measurement can
be taken. This takes approx. 5 seconds.
To leave object temperature mode once more,
hold the M button
7
and the S button
6
at the
same time for 3 seconds again.
If you have activated Bluetooth
®
data transfer, the
data will be transferred after the measurement. The
thermometer displays the symbol for Bluetooth
®
during transfer.
Note: The “HealthForYou“ app must be activated
for transfer to occur. If the current data is not dis-
played on your smartphone, repeat the transfer
process as described in the chapter “Transferring
measured values“.
338571_2001_silv_Multifunktionsthermometer_Content_IE_NI_DK_BE_NL.indd 31338571_2001_silv_Multifunktionsthermometer_Content_IE_NI_DK_BE_NL.indd 31 26.05.20 10:5526.05.20 10:55
To Next Page
Loading...
