Silvercrest SFW 350 C2 - Kibbeh Attachment Assembly; Biscuit Attachments Assembly

SFW 350 C2
■ 8
│
GB
│
IE
│
NI
│
CY
7) Screw the ring clamp . on hand-tight.
8) Assemble the meat grinder casing  as described under “Assembling the
meat grinder”.
Assembling the kibbeh attachment
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing  as described under “Assembling the
meat grinder”.
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing .
NOTICE
► For the kibbeh attachment 1, the cross blade 3 with the spring - is not
required! If need be, remove them both from the meat grinder casing .
The transport screw  remains inside the mincer attachment .
3) Coat all metal parts with cooking oil.
4) If not already done, place the transport screw  inside the mincer attach-
ment .
5) Insert the two plastic parts of the kibbeh attachment 1 so that the fixings
on the bottom kibbeh attachment 1 ring are located in the openings in the
meat grinder casing .
6) When everything has been attached correctly, screw the ring clamp . back
on hand-tight.
7) Assemble the meat grinder casing  as described under “Assembling the
meat grinder”.
Assembling the biscuit attachments
Unfold the fold-out side. There you will find the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing  as described under “Assembling the
meat grinder”.
2) Disassemble any attachments that might be fitted and clean the meat grinder
casing .
NOTICE
► For the biscuit attachment , the cross blade 3 with the spring - is not
required! If need be, remove them both from the meat grinder casing .
The transport screw  remains inside the mincer attachment .
3) Coat all metal parts with cooking oil.
4) If not already done, place the transport screw  inside the mincer attach-
ment .