66 - English
8. Installation
WARNING!
Risk of electric shock and material damage!
There is a risk of electric shock as well as material damage
if the appliance is connected improperly.
The electricity and water supply should only be connect-
ed by a qualified expert.
8.1. Setup and levelling
Install the appliance on a stable, flat surface close to a drain and water connection:
− on a table/work surface
− in a ventilated cupboard.
Only connect the mains plug (20) to a properly installed and freely accessible socket if
the water supply and outlet have been connected correctly (see next section).
8.2. Connecting to a water supply
Before adding water, press the button (18) to switch on the dishwasher.
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk of
damage to the appliance.
The hose must be free of kinks and connected carefully.
Connect the water supply hose (21) to a cold water tap with a 3/4” thread (see Fig.
D). You can also connect the supply hose to a hot water tap if the water temperature
does not exceed 70°C.
This reduces wash time by about 15 minutes.
Screw the hose connection hand tight.
The water hose is designed for a water pressure of up to 10 bar. We recommend closing
the water supply off after use, especially if your house connection does not have a pres-
sure reducer.
To Next Page
Loading...