90 - English
16. Error messages
Error message Problem Solution
Extra dry op-
erating light flash-
es
No water supply detect-
ed or water supply too
slow
Flow rate measurement, drain
valve or pump failure, contact the
service department.
The intensive pro-
gram
, ECO
and quick pro-
gram oper-
ating lights are lit
up permanently
Too little water filled,
No water supply detect-
ed in the first three min-
utes
Fill up the water tank until an
acoustic signal sounds.
Then press the button (13) to
start the appliance.
Extra dry and
ECO operating
lights flash
Wash temperature is not
reached
Heating element/thermistor error,
contact the service department.
The intensive pro-
gram oper-
ating light flashes
quickly
The appliance over-
flows/leaks.
Make sure that the door is closed
correctly and that the water sup-
ply and drain are connected cor-
rectly.
Turn off the water supply.
If water is on the appliance base
due to overfilling, remove the wa-
ter before restarting the dishwash-
er.
Extra dry , in-
tensive program
and quick
program op-
erating lights flash
Error display on control
panel
Contact our Service Centre.
The intensive pro-
gram , quick
program and
ECO operating
lights are lit up
permanently
Insufficient water sup-
plied to the water tank
within 3 minutes.
Fill up the water tank with more
water until a quick acoustic signal
sounds.
Then press the button (13) to
start the appliance.
Salt container (10) is
empty
Replenish the salt container (10)
To Next Page
Loading...
