Silvercrest SHBR 560 B1 - Cleaning and Maintenance; Safety Before Cleaning; Cleaning Material Restrictions; Routine Maintenance Tasks

■ 14
│
GB
│
IE
SHBR 560 B1
2 x
Fig. 18 Fig. 19
Ƈ Activate the continuous spray function
during cleaning with both forward and
backward movements with the appliance. This way, the cleaning solution is
evenly applied to the hard floor via the rotary brush
6.
Ƈ Press the cleaning solution switch
t twice briefly again to deactivate the
continuous spray function.
NOTE
► When cleaning carpets, if you activate the cleaning solution switch
t,
twice as much cleaning solution is applied to the rotary brush 6 as during
hard floor cleaning.
► To allow carpets to dry more quickly after cleaning, move the appliance
several times over the carpet. Do not activate the continuous spray function
while doing so and do not hold down the cleaning solution switch t.
Ƈ Press the carpet switch
e again to switch the appliance off (see fig. 17).
Cleaning and maintenance
RISK OF ELECTRICAL SHOCK!
► Switch the appliance off and pull out the mains plug before cleaning the
appliance!
ATTENTION! PROPERTY DAMAGE
►
Do not use caustic, abrasive or solvent-based cleaning materials. These can
damage the surfaces of the appliance.
NOTE
► Empty the waste water tank
2 after every use.
► Clean the dirt filter
0 after each use and let it dry completely before
putting it back into the waste water tank 2.