Silvercrest SHBR 560 B1 - Handling and Operation; Preventing Component Damage; Continuous Spray Function

GB
│
IE
│
11 ■
SHBR 560 B1
Handling and operation
ATTENTION! PROPERTY DAMAGE!
► While working with the appliance, make sure that the rotary brush
6 does
not get blocked by loose objects lying around on the floor or by carpet
edges. These can damage the rotary brush
6 and stop it from working
properly.
NOTE
► Before finishing the cleaning process, use the appliance approx. 15
seconds without adding cleaning solution. This prevents larger amounts of
water residue being left behind and gives you a better cleaning result.
► A small amount of water may remain on the floor after cleaning for func-
tional reasons. In this case, remove the remaining water from the floor with
a cloth.
Continuous spray function
The appliance has a continuous spray function that allows you to continuously
apply cleaning solution to the rotary brush 6 without having to hold down the
cleaning solution switch t:
Ƈ Press the cleaning solution switch
t twice briefly to activate the continuous
spray function.
Ƈ Press the cleaning solution switch
t twice briefly again to deactivate the
continuous spray function.
Cleaning hard floors
Once the appliance is assembled and the fresh water tank q is filled with water
and cleaning solution:
Ƈ Unwind the power cable
u completely from the upper and lower cable retainers
z/p. To unwind the power cable u quickly from the cable retainers z/p,
pull the upper cable retainer z out a little way and turn it downwards (see
fig. 12).
Ƈ Insert the plug into the mains power socket.