EasyManua.ls Logo

Silvercrest SHBS 3.7 E6 - Trimming a Beard; Trimming a Hairline; Shaving (Hairlines); Trimming Nose and Ear Hair

Silvercrest SHBS 3.7 E6
179 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
GB
8.4 Trimming a beard
NOTE: You use the beard trimmer attach-
ment(4) with the adjustable comb attach-
ment(1).
Please note that the cutting lengths are
only achieved if the slide control(10) is
in position 1 and the device is held at
a right angle (90°) to the skin surface.
Comb the beard in the direction of growth.
Trim the beard downwards from ear to
chin. Trim one side and then the other.
Adjust the slide on the comb attach-
ment(1) to set the cutting length. Read
off the set cutting length via the marking
(3, 4, 5, 6 mm) on the side of the comb
attachment (see Fig.F).
Trim your beard step-by-step.
Use the beard trimmer attachment (4)
without a comb attachment(1) to cut the
beard very short or to cut a moustache
and hairlines.
Use the slide control (10) to
adjust the precision length as
required (level 1: approx. 1.8 mm,
level 2: approx. 1.3 mm, level 3:
approx.0.8mm).
Use the beard trimmer attachment (4)
or the precision trimmer attachment(7)
to trim your moustache. First comb the
moustache straight downwards. Start at
the centre above the mouth and trim one
side and then the other.
8.5 Trimming a hairline
NOTE: You use the precision trimmer attach-
ment(7) to shorten and shape moustaches,
whiskers, sideburns or eyebrows.
Hold the device at an angle of 45° (see
Fig.G).
Place the edge of the precision trimmer
attachment (7) at the desired hairline
height and move the device down-
wards.
8.6 Shaving (hairlines)
NOTE: You use the shaving attachment(8).
Your skin must be clean and dry.
The shaving attachment(8) is only suita-
ble for shaving hairlines.
NOTE: Do not exert excessive pressure on
the shaving foil of the shaving attachment, in
order to prevent damage to the shaving foil.
Hold the device at right angles to the
skin surface and move it gently over
your face.
Shave against the direction of beard
growth.
Stretch your skin in complicated areas,
such as the chin, to achieve better results.
8.7 Trimming nose and ear hair
NOTE: You use the nose/ear hair trimmer
attachment(6).
Insert only the metal tip slowly into a
nostril or an ear.
Slowly move the device in a circular
pattern to trim the hair.

Table of Contents