12
GB
Only hold the shaving foil frame at the
side and do not press against the shav-
ing foil.
3. Clean the cutting blade with the clean-
ing brush (see “Scope of supply“).
4. Clean the shaving foil in the shaving foil
frame under running water.
5. Allow the shaving foil and the shaving
foil frame to dry completely before you
replace the shaving foil frame on the
shaving attachment(8).
6. Replace the shaving foil frame on the
shaving attachment(8).
When doing so, ensure that the fasten-
ing tabs on the shaving foil frame fit into
the appropriate recesses on the shaving
attachment(8) and press the shaving foil
frame gently downwards until it audibly
locks into place.
NOTE: Oil the cutting blade from time to
time as described below.
1. Apply a few drops of acid-free oil (e.g.
sewing machine oil) to the cutting blade.
2. Place the shaving attachment(8) on the
motor unit(9).
3. Allow the device to run for a few sec-
onds without using it.
4. If required, wipe off any surplus oil with
a soft cloth.
10 Storage
• Use the storage bag (see “Scope of
supply“) to protect the device and the
accessories from dust and dirt.
11 Ordering parts
NOTE: You can order accessories for the
5-in-1 hair and beard trimmer online at
shop.hoyerhandel.com.
1. You will need the article number (IAN)
and the model when ordering (see
“Technical specifications“).
2. Scan the QR code with your smart-
phone/tablet.
This will take you directly to the website
(shop.hoyerhandel.com) where you can
place the order.
12 Disposal
12.1 Disposing of the device
The battery integrated in this
device may not be disposed of in
the household waste.
The device must be properly disposed of
with the battery installed. When disposing
of the device, the waste disposal facility
must be informed that the device contains
an integrated battery. The battery is a lithi-
um-ion battery.
To Next Page
Loading...
