68
GB
9.6 Interrupting the
cooking process
NOTE: to stop the cooking process com-
pletely, e.g. in order to return to the basic
setting, press and hold the Start/Stop
button 20.
You can interrupt the cooking process at any
time, e.g. to check the degree of browning.
• Briefly press the Start/Stop 20 but-
ton to interrupt the cooking process.
- The button symbol 20 flashes.
- The heating symbol 24 is no
longer displayed.
- A signal sounds.
- Temperature and cooking time are
displayed alternately for approx.
1minute.
- When the frying basket5 is removed,
the fan stops until the frying basket is
pushed back in.
• Press the Start/Stop button
20
again
to continue the cooking process.
9.7 End of the cooking
process
• An audio signal sounds when the pro-
gram has finished. The fan continues to
run for approx 1 minute before the de-
vice is switched to standby.
• You need a heat-resistant surface and a
plate or bowl (pre-heated if necessary).
• To disconnect the device from the mains
pull the mains plug11 after use.
1. Use the handle9 to pull the pan10 out
of the housing1. Place the pan10 on
the heat-resistant surface.
2. Figure A: slide the safety catch7 in
the direction of the arrow.
3. Press the button for unlocking the frying
basket8 and lift the frying basket5 up-
wards out of the pan10.
4. Place the frying basket5 on the heat-re-
sistant surface. Place the food on the
prepared plate / in the prepared bowl.
5. Allow the device and accessories to
cool down before cleaning them.
NOTE: if, for example, the degree of
browning does not yet meet your require-
ments, you can adapt the cooking process
manually (see “Manual settings” on
page 67). Slide the pan10 with the filled
frying basket5 back into the housing1 and
restart the cooking process. Check the level
of browning after a few minutes (see “Inter-
rupting the cooking process” on page 68).
__334460_1910_Heissluftfritteuse_B5.book Seite 68 Montag, 20. Juli 2020 12:08 12
To Next Page
Loading...
