Silvercrest SHLF 2000 B2 User Manual

9
GB
4. In order to switch back to standby mode,
press the standby button 
23 again.
After a few seconds stopping time, the
device switches into standby mode.
NOTE: the device requires electricity in this
state.
5. In order to completely switch off the de-
vice, set the main switch9 to 0.
6.2 Setting the heat output
•Press Mode21 repeatedly until the de-
sired heat setting is shown on the dis-
play10:
6.3 Selecting the temperature
• The button +  20 allows you to increase
the desired temperature up to 38 °C, while
the button
-  22 allows you to reduce the
desired temperature down to 6°C.
The selected desired temperature is shown
on the display34.
The room temperature is measured by the
temperature sensor8 and shown on the dis-
play33.
The device switches off automatically once
the room temperature has reached the de-
sired temperature. If the room temperature
falls below the desired temperature, the de-
vice automatically switches back on again.
6.4 Setting the running time
The device has a timer24, with which you
can set the desired running time. The run-
ning time can be set at between 1 minute
and 23 hours 59 minutes.
Upon reaching the end of the running time,
the device switches off automatically and
End appears on the display.
1. Press the button 24 in order to ad-
just the timer setting.
The hour indicator flashes.
2. Press the button +
 20 / -22 in order to
set the hours.
3. Press the button 24.
4. Press the button +
 20 / -22 in order to
set the minutes.
5. Press the button 24 in order to start
the timer.
NOTE: by keeping the buttons +  20 or -  22
pressed, the values toggle until you release the
button.
The selected running time is shown on the
display10.
6.5 Swivel function
The device has a swivel function.
It causes the device to swivel to and fro, thus
distributing the escaping air more evenly in
the room.
• By pressing button 25, you can
switch the swivel function on and off.
6.6 Overheating protection
This device possesses overheating protec-
tion for your safety.
If the temperature inside the device becomes
too high, it automatically switches off:
1. Switch the device off by setting the main
switch9 to 0.
2. Check whether the air inlet or air outlet
are obstructed and eliminate the cause.
If the cause cannot be found and the
Low heat output: device oper-
ates at 1,000 watt
High heat output: device oper-
ates at 2,000 watt
Automatic mode: the device au-
tomatically adapts the heat out-
put to the room temperature.
Frost protection: the device only
switches on at 6 °C ambient
temperature.
BB&3(B%ERRN6HLWH'LHQVWDJ0DL

Silvercrest SHLF 2000 B2 Specifications

General

Brand	Silvercrest
Model	SHLF 2000 B2
Category	Heater
Language	English