Silvercrest SKMP 1300 D3 - Adding Ingredients; Using and Removing the Blade Assembly; Using the Blender Jug

17
GB
6. Place the mixing tool20/21/22 onto
the axle23 from below.
Adding ingredients
• You can add ingredients into the mixing
bowl16 while the drive arm19 is lift-
ed up.
Lowering the drive arm
DANGER of hand injuries by
crushing!
~ Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
7. Press the unlock button11 and move
the drive arm19 all the way down.
Using the blender jug
DANGER! Risk of injury from
cutting!
~ Please remember that the blades of the
blade assembly7 are very sharp.
Using and removing the blade
assembly
The blender jug5 must never be used with-
out the blade assembly7, since the blade
assembly7 seals the blender jug5 on the
bottom.
In order to remove the blade assembly7,
proceed as follows:
1. Turn the blender jug5 upside down.
2. Turn the blade assembly7 clockwise at
the two handles25 until the knife as-
sembly comes loose.
3. Pull out the blade assembly7 carefully.
In order to insert the blade assembly7, pro-
ceed as follows:
1. Turn the blender jug5 upside down.
2. Place the blade assembly7 carefully
into the blender jug5.
Turbo
1
0
2
3
4
5
6
25
25
__367924_367925_2101_Kuechenmaschine_B8_KURZ.book Seite 17 Freitag, 26. März 2021 8:42 08