Silvercrest SKT 2300 A1 User Manual

SKT 2300 A1 7
3.8 Material damage
Caution! To avoid material damage, please
observe the following conditions.
• Remove the batteries from the remote
control if you are not using it for a
prolonged period of time. Leaking
batteries could damage the remote
control.
• Ensure that the feet are fitted correctly
(see “4.2 Setting up the appliance” on
page 7), otherwise the floor might be
scratched or scorched.
4. Unpacking, setting up and inserting the batteries
4.1 Mounting the appliance
Before the appliance can be used, the feet 7
must be screwed on as follows:
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
4. Insert the hooks on the feet into the
corresponding openings on the bottom
of the appliance:
5. Slide the feet to one side to allow the
hooks to engage.
6. Secure the feet firmly using the supplied
screws:
4.2 Setting up the appliance
Note: As the appliance and heating
elements are supplied with a thin film of
grease, there might be a
small amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop
after a short while. Please ensure meanwhile
that there is sufficient ventilation.
Warning! Ensure that there is
sufficient distance from the wall,
fixtures and other appliances. The
distance must be at least 1
m to
exclude the risk of fire.
1. Select a location in compliance with the
safety information
(see “3. Safety
information” on page 4).

Silvercrest SKT 2300 A1 Specifications

General

Brand	Silvercrest
Model	SKT 2300 A1
Category	Heater
Language	English