Silvercrest SLE 320 A2 - Handling and Operation; Powering On and Off; Air Outlet Valve Usage

GB
│
11 ■
SLE 320 A2
Handling and operation
In this section, you will receive important information pertaining to appliance
handling and operation.
Switching the appliance on/off
♦ Press the STANDBY button
21
to switch the appliance on. The OPERATION
LED
20
lights up.
♦ Press the STANDBY button
21
to switch the appliance off. The OPERATION
LED
20
goes out.
NOTE
►
The appliance starts in the mode last selected.
► After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating guard, the appliance starts in
the mode last selected.
♦ If a timer has been programmed, the appliance switches off definitively
upon lapse of the time specified (1-24 hour/s).
♦ If the relative humidity value has been defined in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦ The appliance switches off if the water tank
5
is full or has been removed.
If wrongly positioned, or if the water tank
5
has been removed, the TANK
FULL LED
19
lights up when the appliance is switched on and an audible
signal is emitted.
NOTE
► The water tank
5
must be fully inserted in the appliance; otherwise, the
condensate cannot be collected properly.
Air outlet valve
Always open the air outlet valve, regardless of the appliance's respective pro-
gramme. If the valve is not opened, the overheating guard switches the appli-
ance off after some time for approx. 3 minutes.