Silvercrest SMK 1000 A1 - Preparing Compote

GB
│
7 ■
SMK 1000 A1
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button  repeatedly until the
programme indicator for the programme you
want to use starts to flash.
– SMOOTH
- for creamy, pureed soups
– CHUNKY
3 for chunky soups.
7) Press the START/STOP button 6. The appli-
ance beeps. The programme indicator of the
selected programme lights up permanently.
Preparation of the soup now takes place automat-
ically. The appliance heats and mixes at regular
intervals.
NOTE
► You can stop the preparation process at any
time by pressing the START/STOP button 6
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete,
the appliance will stop automatically. The appli-
ance will beep and the relevant programme indica-
tor of the set programme flashes.
8) Remove the plug from the mains power socket
and the connector  from the built-in plug .
9) Remove the lid  carefully from the blender
jug  and place it to one side.
WARNING! RISK OF INJURY!
► Be careful when opening the lid .
Hot vapour can escape! We recommend the
use of oven gloves.
You can now serve the soup in bowls or a soup
terrine.
NOTE
► Clean the appliance after every use (see
section "Cleaning and care"). Otherwise resi-
dues from the previous cooking process that
may be left on the bottom of the container
could burn.
Preparing compote
1) Cut the fruit/vegetables into pieces of around
2 cm and place these in the blender jug .
2) Fill the blender jug  up to no more than the
MAX - 1600 ml marking with water or other
liquids. Always fill up to at least the MIN -
1300 ml marking!
3) Place the lid  on the blender jug . Ensure
that the contact plug  in the lid  fits cor-
rectly in the safety socket .
4) Insert the connector  into the built-in plug 
on the appliance.
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button  repeatedly until the
COMPOTE programme indicator
! starts
to flash.
7) Press the START/STOP button 6. You will hear
a beep and the COMPOTE programme indica-
tor
! flashes.
Preparation of the compote now takes place auto-
matically. The programme runs for 13 minutes.
NOTE
► You can stop the preparation process at any
time by pressing the START/STOP button 6
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete, the
appliance will stop automatically. You will hear
a beep and the COMPOTE indicator light
!
flashes.