Silvercrest SMK 1000 A1 - Low Liquid Level Control

■ 10
│
GB
SMK 1000 A1
Low liquid level control
The integrated low liquid level control prevents the
appliance from starting when there is no liquid in
the blender jug .
Cleaning and Care
Ideally, you should clean the appliance immediate-
ly after use. Dried food residue is more difficult to
remove.
DANGER –
RISK OF ELECTRICAL SHOCK!
► Ensure that no moisture can get into/onto the
built-in plug  and the safety socket  on
the blender jug !
► Ensure that no moisture can get into/onto
the contact plug  on the lid on the blender
jug !
Never immerse the lid  in water or other
liquids! Otherwise there is a risk of an
electric shock.
WARNING! RISK OF INJURY!
► Take care when cleaning the lid  and the
attached blades ! The blades  are
extremely sharp!
1) Add a little warm water and a drop of washing
up liquid to the blender jug .
2) Place the lid  on the blender jug . Ensure
that the contact plug  in the lid  fits cor-
rectly in the safety socket .
3) Insert the connector  into the built-in plug 
on the appliance.
4) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
5) Press the MODE button  repeatedly until the
BLEND programme indicator
0 starts to
flash.
6) Press and hold the START/STOP button 6 and
allow the appliance to run for about 20 seconds.
7) Remove the power plug from the mains power
socket.
8) Remove any stubborn residue in the blender
jug  or the blades  using a washing up
brush or a washing up sponge.
9) Afterwards, empty the blender jug  and
rinse it out thoroughly with clear water.
10) Wipe the exterior surfaces of the blender jug 
with a moist cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water
to ensure that no detergent remains on the
appliance.
11) Wipe the lid , blades  and sensor  with
a damp cloth. If required, use a mild wash-
ing-up liquid on the cloth. Afterwards, wipe off
with a cloth moistened only with clear water to
ensure that no detergent remains on the appli-
ance. Ensure that no moisture can get into the
contact plug on the lid on the blender jug !
12) Wipe the mains cable with a damp cloth.
13) Dry all parts well before re-use.
Storage
■ Store the cleaned appliance in a clean, dust-free
and dry location.