SND 4600 A1
GB
│
IE
│
17 ■
Colour and brightness settings
♦ Adjust the colours and brightness as required by clicking on the
“Color/Brightness Adjustment” button (K).
♦ Move the “Brightness” slider to set the brightness between
0 and 255.
♦ Move the three “Color Balance” sliders to set the RGB values
between 0 and 255.
♦ To reset to the default values, click on the “Reset” button.
After use
♦ Remove the negative holder 5 by pushing it all the way through
the device.
♦ Remove the slide magazine
6 by pulling it back out of the
slot 4 on the right.
♦ Remove the USB cable
8 from the USB port on your computer
and the scanner.
To Next Page
Loading...
