EasyManua.ls Logo

Silvercrest SPB 6000 A1 - Component Identification and Initial Setup; Device Components and Package Check

Silvercrest SPB 6000 A1
58 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
MT
 33
SPB 6000 A1
DANGER! Mishandling the batteries can cause fires, ex-
plosions, leakages or other hazards! Do not throw the device
into a fire, since the integrated battery may explode.
Comply with all restrictions or prohibitions on use for bat-
tery-powered devices in locations with specific hazard risks,
such as petrol stations, aeroplanes, hospitals, etc.
Descriptions of components
(See fold-out page for illustrations)
Power Bank
USB plug (input: 5 V , 2.1 A)
ON/OFF button
Micro-USB plug (output: 5 V , 2.1 A)
USB port (output: 5 V , 2.1 A)
Micro-USB port (input: 5 V , 2.1 A)
USB port (output: 5 V , 1 A)
Charge level LEDs
Operating instructions
Cable (USB to microUSB)
Operation
Check the package contents
(See fold-out page for illustrations)
The following components are included:
Power Bank SPB 6000 A1
USB cable
These operating instructions
Remove all parts of the device from the packaging and remove
all packaging materials.
NOTE
Check the package for completeness and for signs of
visible damage.
If the delivery is incomplete or damage has occurred as
a result of defective packaging or during transport, con-
tact the Service hotline (see chapter entitled Service).

Table of Contents

Related product manuals