GB
│
MT
│
35 ■
SPB 6000 A1
Option B
♦ Connect the Micro-USB cable to the Micro-USB input
on the Power Bank.
♦ Connect the other end of the micro-USB cable to a USB pow-
er supply (not supplied).
A rough estimate of the current charge level is shown during
charging by means of the charge level LEDs
.
CAUTION!
► Do not use both charging options simultaneously as this
could damage the power bank or your mains adapter.
Checking the charge level
You can also check the charge level of the Power Bank when
it is not charged or while it is being used for charging.
♦ Press the ON/OFF button
briefly. The LEDs show the
current charge level of the Power Bank for about 20 seconds.
LED display Charge level
All LEDs are on 100%
Three LEDs are on 75–99%
Two LEDs are on 50–74%
One LED is on 20–49%
One LED is flashing < 20%
All LEDs off 0%
Handling and operation
Charging mobile devices with the
Power Bank
You can charge up to three devices at a time using the Power
Bank. When all three outputs are being used, the total charg-
ing current may not exceed 2.1 A.
♦ Connect a suitable USB charging cable to the corresponding
USB output ( or ) of the Power Bank for each device
being charged.
♦ Then connect the USB charging cable to the device to be
charged. The charging process starts automatically.
To Next Page
Loading...
