Silvercrest SPB 6000 A1 - Power Bank Operation; Charging the Power Bank

■ 34
│
GB
│
MT
SPB 6000 A1
Disposal of packaging materials
The packaging protects the device from damage
during transport. The packaging materials have
been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
Returning the packaging into the material cycle conserves
raw materials and reduces the amount of waste generated.
Dispose of packaging materials that are no longer needed in
accordance with applicable local regulations.
Charging the Power Bank
Before using the Power Bank, the integrated battery must be
fully charged. The required charging time for the Power Bank is
dependent of the charging source and its output (max. 5V/2.1A).
CAUTION!
► Due to the high battery capacity and bearing in mind
the charging time, we recommend charging the power
bank using a USB mains adaptor (not supplied).
► Use only a USB mains adapter with an output voltage
of 5 V and an output current of at least 2.1 A to charge
the power bank.
Option A
♦ Connect the USB plug of the power bank to a USB power
supply (not supplied).
A rough estimate of the current charge level is shown during
charging by means of the charge level LEDs :
LED display
Charge
level
One LED is flashing < 25%
One LED is on, the second LED is flashing 25–49%
Two LEDs are on, the third LED is flashing 50–74%
Three LEDs are on, the fourth LED is flashing 75–99%
All LEDs are on 100%