Silvercrest SPR 330 A1 - Troubleshooting Common Issues

■ 18
│
GB
│
IE
SPR 330 A1
Troubleshooting
The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Cause Remedy
The appliance
will not switch
on.
The appliance is not
switched on.
Make sure that the appliance is properly
connected to the power supply. Press the
On/Off switch
2 to turn on the appliance.
The power plug
6 is
not plugged in.
Insert the power plug 6 into the mains socket.
The mains socket is
not supplying any
power.
Check the house mains fuse.
The appliance is
defective.
Contact the Customer Service department
(see section Service).
The suction
power is too
weak.
The fresh and waste
water tanks
s/3
are not fitted properly
in the appliance.
Attach the fresh and waste water tanks
s/3
properly to the appliance (see sections Filling
the fresh water tank and Cleaning the waste
water tank).
The waste water
tank
3 is full.
Empty the waste water tank
3 (see section
Cleaning the waste water tank).
The suction opening
u is blocked.
Clean the cleaning attachment and remove the
blockage (see section Cleaning the handle
and cleaning attachment).
The dirt filter
a is
blocked.
Remove the dirt filter a and clean it (see
section Cleaning the waste water tank).
The spray
nozzle
t is
not discharging
enough water/
cleaning
solution.
The fresh water tank
s is empty.
Fill up the fresh water tank
s (see section
Filling the fresh water tank).
Water is
leaking from
the appliance.
The fresh water tank
s is not properly
sealed.
Take the fresh water tank
s out of the appli-
ance and make sure that the seal is properly af-
fixed (see section Filling the fresh water tank).