■ 10
│
GB
│
IE
SRBN 5 A1
Troubleshooting
This section contains important information about fault identification and rectifica-
tion. Follow the instructions to avoid hazards and damage.
Fault causes and rectification
The following table will help you to identify and rectify minor malfunctions:
Faults Possible cause Remedy
Device does not
switch on.
The plug is not connected.
Insert the power plug into the
socket.
The mains power socket is not
supplying power.
Check the house mains fuse.
The main switch is set to the OFF
position.
Set the main switch to the ON
position.
No sound.
The volume on the device or the
playback device is set to minimum.
Increase the volume on the device
or on the playback device.
Playback has not been started on
the playback device.
Start playback on the playback
device.
Interference
with the radio
reception.
The station is not properly tuned
in.
Use the TUNING dial to tune the
desired radio station.
The reception is weak.
Try to improve reception by
realigning the telescopic aerial.
The Blue-
tooth
®
connec-
tion cannot be
established.
Possibly, not all of the Bluetooth
®
devices are compatible.
Check the settings on your
Bluetooth
®
device.
Bluetooth
®
transmission is
not activated on your playback
device.
Switch on Bluetooth
®
transmis-
sion on your playback device.
Please refer to its operating
instructions for more information.
The playback device is not paired
with the device.
Repeat the pairing process (see
section Bluetooth
®
mode).
The distance between the device
and the playback device is too
great.
Ensure that the device is no more
than 10 metres away from the
playback device.
Playback sounds
distorted in AUX
mode.
The volume is set too high on the
external playback device.
Reduce the volume on the external
playback device.
NOTE
► If you cannot solve the problem with the above-mentioned solutions, please
contact the Service Hotline (see chapter entitled Service).
To Next Page
Loading...
Need help?
General
