GB
│
MT
│
37 ■
SRBX 2200 A1
♦ Slide the brush head holder
8
onto the extension rod
6
so that the release
button on the extension rod
6
locks into the latch of the brush head holder
8
.
To use the appliance without the extension rod
6
, proceed as follows:
♦ Slide the brush head holder
8
onto the handle
3
so that the release
button
5
on the handle
3
locks into the latch of the brush head holder
8
.
♦ To disassemble the components again, press the corresponding release
button
5
/
7
and pull the brush head holder
8
or the extension rod
6
off.
Selecting and fitting accessories
RISK OF ELECTRIC SHOCK
► Always disconnect the mains adapter
13
from the mains power socket and
switch off the appliance before changing accessories.
♦ You can choose from three different brush heads.
Choose the appropriate brush head:
Flat brush head
The flat brush head
11
is suitable for cleaning large, even surfaces, such as
floors and walls.
Domed brush head
The domed brush head
10
is suitable for cleaning uneven surfaces, such as
sinks and fittings.
Conical brush head
The conical brush head
12
is suitable for cleaning spots that are difficult to
access, such as corners and joints.
♦ Slide the correct brush head
10
/
11
/
12
onto the drive shaft
9
of the brush
head holder
8
until you feel it lock into place. Ensure that the two latches
on the drive shaft
9
slide into the corresponding gaps on the brush head
10
/
11
/
12
.
♦ To remove the brush head
10
/
11
/
12
from the appliance, simply pull it off
with a little force
8
.
To Next Page
Loading...
