8
GB
~ Should liquid enter the device, have it checked before start-
ing the device up again.
~ If the device is used in a bathroom, the power unit must be
pulled out after use, as the proximity of water represents a
hazard, even when the device is switched off.
~ Installation of a residual current device (FI/RCD) with a rat-
ed residual operating current of no more than 30 mA is rec-
ommended to provide additional protection. Ask your
electrician for advice. The installation should only be carried
out by a qualified electrician.
DANGER! Risk of electric shock
~ Do not start using the device if the device, the battery charg-
er or the plug-in power unit show visible damage, or if the
device has previously been dropped.
~ Connect the plug-in power unit to the device/battery charger
before plugging it into a wall socket.
~
Lay the cable of the plug-in power unit such that no one can
step on it, get caught on it, or trip over it.
~ Only connect the plug-in power unit to a properly installed
easy to access wall socket which supplies voltage matching
the rating plate. The wall socket must continue to be easily
accessible after the device is plugged in.
~ Ensure that the cable of the plug-in power unit cannot be
damaged by sharp edges or hot surfaces. Do not wrap the
cable around the device (risk of cable damage!)
~ Ensure that the cable is not trapped or crushed.
~ When removing the plug-in power unit from the wall socket,
always pull the plug-in power unit and never the cable.
BBB5RWDWLRQVUDVLHUHUB3UHPLXPB%ERRN6HLWH)UHLWDJ1RYHPEHU
To Next Page
Loading...
Need help?
General
