Silvercrest SRRP 3.7 A1 - Beard Trimmer Attachment

20
GB
7. Push the blade unit|5 and the shaving attachment|6 back to-
gether and close the blade unit|5, so that it clicks into place.
8. Push the shaving attachment| 6 back onto the shaver|9 , and
ensure that it clicks firmly into place.
NOTE: for thorough cleaning, an ultrasonic bath is recommended.
Dry cleaning of the nose hair trimmer
• Dry clean the nose hair trimmer|4 after every use.
• Tap it out lightly and then, remove the remaining hair using
a cleaning brush|24.
7.3 Beard trimmer attachment
• Remove the comb attachment|1. Rinse the comb attach-
ment|1 with water and let it dry before reattaching it to the
device.
• Remove the hair remnants from the beard trimmer attach-
ment|3 by using the cleaning brush|24 included in the deliv-
ery.
• Every 6 months or so, apply a few drops of oil to the cutting
edge of the beard trimmer attachment|3. Using a soft, lint-
free cloth, wipe off the surplus oil, if necessary. Only use
acid-free oil, such as e.g. sewing machine oil.
BBB5RWDWLRQVUDVLHUHUB3UHPLXPB%ERRN6HLWH)UHLWDJ1RYHPEHU