12 GB/IE/NI
Before first use
Remove the packaging. Check if all parts are
complete.
During production, some parts are covered
with a thin oil film for their protection.
Before first use, operate the product without
any food so that any potential residues
evaporate.
Clean the product and its accessories (see
the “Cleaning and care” section).
NOTES:
The first few times the product is heated up, a
faint odour may be present. Ensure sufficient
ventilation in the area.
Discard the first set of waffles.
Assembly
m WARNING! Risk of electric shock.
Before installing/removing the plates
[]
,
[]
,
[]
:
Disconnect the power plug [4] from the wall
outlet.
DANGER! Risk of burns. Do not
change/remove the plates
[]
,
[]
,
[]
right
after operation. Let the product cool first.
Installing the plates
Open the lock [1]. Open the product.
Place the inner catch
[]
of the chosen plate
into the large hook catches [7].
Push down the plate until it clicks in place.
Repeat on the other side of the product.
NOTE: Install only plates of the same type.
Removing the plates
Open the lock [1]. Open the product.
Pull the release levers [8]. Remove the plate.
Repeat on the other side of the product.
Operation
Preparation: Grease the upper and
lower exchangeable plates
[]
,
[]
,
[]
with
suitable cooking oil.
Turning the product on: Connect the power
plug [4] to a suitable wall outlet. The red
indicator [2] lights up.
Turning the product off: Disconnect the
power plug from the wall outlet. The red
indicator [2] goes off.
Keep the product locked while preheating.
Preheat until the green indicator [3] lights up.
Light indicator Status
Red indicator [2] on
Product on
Red indicator [2] off
Product off
Green indicator [3] off
Product is preheating/
reheating.
Green indicator [3] on
The baking
temperature has been
reached.
To Next Page
Loading...
