Silvercrest SST 40 A1 Short Manual

GB
│
IE
│
11 ■
SST 40 A1
Operation
Using the appliance
CAUTION
► The suction opening must always be open and must not be blocked. Blockages
lead to overheating and damage to the motor.
► Do not vacuum shag pile carpets with the floor nozzle r. The rotary brush u
can become tangled in the carpet and jam.
NOTE
► Make sure that the HEPA filter p and the coarse filter o are always inserted
before using the appliance.
► As soon as the suction power noticeably decreases and the last indicator
lamp 7 flashes green, connect the appliance to the mains adapter l.
♦ Slide the On/Off switch
1 to the required level (see section Adjusting the
suction power). The indicator lamp 7 lights up green, the LED light i on the
floor nozzle r lights up and the rotary brush u starts turning.
♦ Move the floor nozzle r over the areas to be vacuumed. Hold the handle 2
so that the floor nozzle r slides flat over the floor.
♦ Slide the On/Off switch
1 to position 0 when you want to stop vacuuming.
The rotary brush u stops, the indicator lamp 7 and the LED light i go off.
Adjusting the suction power
Level 1
This level is suitable for simple cleaning work. The operating noise level is low.
The appliance will achieve the maximum runtime.
Level 2
This level is suitable for normal cleaning work. The appliance will achieve a medium
runtime.
Level 3
This level is suitable for demanding cleaning work. The appliance will achieve the
shortest runtime.
NOTE
► Always vacuum at level 3 when using additional accessories in order to achieve
optimum vacuuming results.
IB_329834_SST40A1_LB8_short.indb 11 24.09.2021 08:31:45

Silvercrest SST 40 A1 Specifications

General

Brand	Silvercrest
Model	SST 40 A1
Category	Vacuum Cleaner
Language	English