Silvercrest SST 40 A1 - Troubleshooting Common Issues

■ 14
│
GB
│
IE
SST 40 A1
Troubleshooting
The following table will help you to identify and rectify minor malfunctions:
Fault Possible cause Remedy
The appliance is
not working.
The battery is not charged.
Connect the appliance to
the mains adapter l.
The appliance is defective.
Contact the Customer Service
department.
The appliance is
sucking up hardly
any dirt.
The battery is not sufficiently
charged.
Connect the appliance to
the mains adapter l.
The dirt container 0 is full. Empty the dirt container 0.
The HEPA filter p is clogged. Clean the HEPA filter p.
The appliance will
not charge.
The mains adapter l is not
inserted correctly into the
connecting socket
4/
the mains socket.
Check the connections of
the mains adapter l.
The mains adapter l is
defective.
Contact the Customer Service
department.
The appliance will
not charge and all
indicator lamps 7
are flashing green.
The appliance has been
charged too many times
in quick succession. The
overheat protection has
been triggered.
Disconnect the mains adapter
l from the mains socket. Pull
the barrel plug k out of the
connecting socket
4 of
the appliance. Wait a short
while and try again
.
NOTE
► If you cannot solve the problem with the above-mentioned steps, please contact
the Service Hotline (see section Service).
IB_329834_SST40A1_LB8_short.indb 14 24.09.2021 08:31:46