SUR 48 C4■ 8
│
GB
│
IE
Handling and operation
DANGER!
Danger due to ultrasonic waves!
► During the cleaning process, do not touch the inner surface of the stainless
steel bath or the cleaning fluid: ultrasonic waves can cause serious health
damage.
CAUTION!
► Before connecting the appliance, compare the connection data (voltage
and frequency) on the rating plate with that of your mains power supply.
These data must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over
hot surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
► Always remove the mains plug from the wall socket after each use.
Filling the appliance with cleaning fluid
♦ Open the lid
6
.
♦ Fill the stainless steel bath
7
with the cleaning fluid.
The parts to be cleaned must be covered with the cleaning fluid.
Do not exceed the maximum fill level MAX
8
even after placing the item in
the fluid.
NOTE
► Cold, clean tap water is generally best suited as cleaning fluid. The cleaning
effect can be enhanced by the addition of approximately 3 drops of washing-
up liquid. Do not use caustic cleaners, ammonia, bleach or heavily
perfumed detergents.
► The cleaning performance is dependent on the amount of water: the more
water, the lower the cleaning performance.
♦ Place the objects to be cleaned in the ultrasonic cleaner. The item to be
cleaned only needs to be covered in water. Use the
9
, , or
inserts.
♦ Now close the lid
6
.
To Next Page
Loading...
Need help?
General
