Silvercrest SV 120 A1 User Manual

■ 64
│
GB
│
MT
SV 120 A1
Vacuum sealing
Vacuuming the tube film
You can also suck the air out of the bag (vacuum) during welding:
NOTE
► Do not evacuate bags that contain only liquids. These could be sucked up
during the vacuum sealing process.
If small quantities of liquid or food do get sucked up, they will be deposited
in the small drip tray that is located between the lower sealing ring 5.
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
and so that the appliance lid 1 clicks into place and locks shut.
NOTE
► Ensure that the upper 0 and the lower sealing rings 5 are not damaged!
Otherwise the device cannot suck the air out of the bag.
► If either one of the sealing rings 0/5 is damaged, simply pull it out of the
groove and press the replacement sealing ring into the groove.

Silvercrest SV 120 A1 Specifications

General

Brand	Silvercrest
Model	SV 120 A1
Category	Food Saver
Language	English