GB
│
MT
│
67 ■
SV 120 A1
Cleaning
DANGER
Risk of fatal injury from electrocution!
► Remove the plug from the mains power socket before beginning to clean
the device.
► Ensure that no moisture can penetrate the device during cleaning.
CAUTION
Possible damage to the appliance.
► Do not use aggressive or abrasive cleaning agents, as these may corrode
the surface of the casing.
► Do not use any hard or sharp objects to remove any adhesive from the
welding wire 4. Otherwise the welding wire 4 or the insulation could
be damaged.
Cleaning the appliance
♦ Clean the surface of the housing of the appliance with a lightly moistened
cloth and a mild detergent.
♦ Wipe off the upper 0 and the lower sealing rings 5, as well as the press
seal q with a damp cloth. Ensure that the appliance is dry before using it again.
♦ Wipe the vacuum hoses u/p, the suction cup i and the adapters o/a/
s/d with a damp cloth. If there is heavy soiling, you can also clean these
parts in hot water with a little detergent. Ensure that all components are
completely dry before the next use.
♦ Clean the drip tray that is located between the lower sealing ring 5 in warm
water with a little detergent.
You can also clean the drip tray in the dishwasher, if required. Make
sure that the drip tray does not get jammed in the dishwasher. Use
the upper basket in the dishwasher if possible.
To Next Page
Loading...
Need help?
General
