Silvercrest SWGD 3000 A2 - Product Activation and Modes; Boiling Water Functions

12 GB/IE/NI/CY
 Operation
m
WARNING! Danger of burns! The
lid [3] must remain closed when pouring hot
water. Otherwise, hot water or steam could
escape over the rim causing burns.
 Placing the product
 Keep the power cord [6] as short as possible.
Wrap the excess power cord onto the cord
storage [8] (bottom of the base [9]).
 Guide the power cord [6] through the power
cord guide [7].
 Place the base [9] on an even, stable surface.
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam.
 Turning the product on
 Fill the water kettle [] with water through the
lid’s [3] filler flap [2].
 Place the water kettle [] onto the base [9].
 The product beeps twice to indicate that it is
turned on.
 All buttons [] [] [] [] light up. The
digital display[] shows the current water
temperature.
 The LED ring [] lights up and then goes off.
The product changes to standby mode.
 Standby mode/Shut down
mode
 Standby mode: The standby mode remains
activated for 3minutes after any operation.
During this time, the indicator lights are on.
 Shut down mode: Without any operation
in 3minutes, the indicator lights go off. The
product changes to shut down mode.
In shut down mode, press any button to
reactivate the product. The product changes to
standby mode.
 Boiling water
(without temperature setting)
 Turn on the product (see “Turning the product
on”).
 Press

[] to start boiling water to 100 °C.
 The LED ring [] lights up and changes its
colour with the water temperature.
Colour Temperature (approx.)
Purple ≤ 50 °C
Dark blue 51–70 °C
Light Blue 71–80 °C
Green 81–90 °C
Red ≥ 91 °C
 A long beep sounds once the water reaches
100 °C. The product changes to standby
mode.
 When the water is boiling:
Indicator Status
[]
On
[]
On
–
[]
Off
+
[]
Off