11 GB/IE/ NI/CY
m
Burn hazard! Do not open
the lid while the water is boiling.
The product‘s lid must remain
securely closed while the
product is in use.
If you notice any smoke or
unusual noises, immediately
disconnect the product from the
power supply. Have the product
checked by a specialist before
continued use.
m
WARNING! Do not use
the product if the water kettle
shows cracks or other signs of
damages.
Placing the product
The product must not be placed
directly below a power supply.
Always use the product on a
flat, stable, clean, heat-resistant
and dry surface.
Operation
The product shall only be used
with the supplied base.
Do not overfill the product. If
the product is overfilled, boiling
water may be ejected. Do not
operate the product without
water. The fill level of the
product must be between the
MIN and MAX marks on the
water gauge.
Cleaning and storage
The product shall not be
exposed to any dripping or
splashing water.
Disconnect the product from the
power supply before cleaning
and when not in use.
Refer to the “Cleaning and
care” section for instructions on
how to clean the product.
Before first use
Remove all the packaging materials.
Clean the product (see “Cleaning and care”).
Boil the maximum water volume of 1.7 litres
(see „Operation“). After boiling, discard the
water to remove any production and transport
residues.
To Next Page
Loading...
