Silvercrest SWGD 3000 A2 - Keeping Warm Functions

13 GB/IE/ NI/CY
 Boiling water
(with temperature setting)
 Turn on the product (see “Turning the product
on”). Press [].
 Press – [] or + [] to set the desired
temperature from 40 °C to 100 °C with an
interval of 5 °C.
 If you reach the upper or lower end of the
available temperature range, 2 beeps sound.
 A long beep sounds once the water reaches
the desired temperature. The product changes
to standby mode.
 When the water is boiling:
Indicator Status
[]
On
[]
On
–
[]
Off
+
[]
Off
 Keeping warm
(without temperature setting)
 Turn on the product (see “Turning the product
on”).
 Press

[]. Then press

[] within
3 seconds to start boiling.
 A beep sounds once the water temperature
reaches 90°C. The water is kept warm for
1hour.
 A long beep sounds after the water has been
kept warm for 1 hour. The product changes to
standby mode.
 The keep warm function can be set after the
water has been boiled. The procedure is the
same as described before in this section.
 When the water is kept warm:
Indicator Status
[]
On
[]
Flashing
–
[]
Off
+
[]
Off
 Keeping warm
(with temperature setting)
 Turn on the product (see “Turning the product
on”).
 Press

[].
 Press – [] or + [] to set the desired
temperature from 40 °C to 90 °C with an
interval of 10 °C.
 If you reach the upper or lower end of the
available temperature range, 2 beeps sound.
 Start heating up the water: Press

[]. A
beep sounds once the water reaches the
desired temperature. The water is kept warm
for 1hour.
 A long beep sounds after 1 hour. The product
changes to standby mode.
 The keep warm function can be set after the
water has been boiled. The procedure is the
same as described before in this section.