EasyManua.ls Logo

Silvercrest SWGD 3000 A2 - Cancelling and Turning Off; Maintenance and Care; General Cleaning Procedures; Strainer Cleaning and Maintenance

Silvercrest SWGD 3000 A2
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14 GB/IE/NI/CY
When the water is kept warm:
Indicator Status
[]
On
[]
Flashing
[]
Off
+
[]
Off
Cancel boiling or keeping
warm
Press
[], while the water is being boiled
or kept warm. The product changes to standby
mode.
Turning off
Without any operation in 3minutes, the
product changes to shut-down mode.
Press and hold
[] for 3 seconds to turn
off the product.
Cleaning and care
m
WARNING! The product shall not be
immersed in water or other liquids. Do not
hold the product under running water.
Always disconnect the product from the power
supply before cleaning.
Check the product prior to each use for visible
signs of damage.
Cleaning
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product.
Clean the product with a slightly damp cloth.
Use a mild detergent, if necessary.
Rub all parts dry with a clean cloth.
Care
Cleaning the strainer [1]
Fig.
Remove the lid [3].
B
Gently pull on the strainer‘s [1]
clip to release it.
C
Rinse the strainer [1] with fresh
water.
If scale deposits have set on the
strainer [1], soak it for a few
hours in a water-vinegar solution
(5 to 15 %). The scale deposits
will dissolve themselves.
Rinse the strainer [1] with copious
amounts of fresh water.
Place the strainer [1] with its top
edge on the top of the water
kettle [].
D
Press the strainer [1] firmly into
position.
E

Table of Contents

Related product manuals