Silverline 1500W Electric Breaker User Manual

Silverline 1500W Electric Breaker

40 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

www.silverlinetools.com

263570

1500W Electric Breaker

1500W Electric Breaker

Marteau piqueur électrique 1 500 W

Elektro-Abbruchhammer, 1500 W

Martillo de demolición 1500 W

Demolitore elettrico 1500 W

1500 W elektrische breekhamer

S

I

L

V

E

R

L

I

N

E

R

A

N

G

E

263570_Z1MANPRO1.indd 3 12/10/2015 11:11

Table of Contents

Questions and Answers:

J
Jake JacksonAug 12, 2025
What to do if my Silverline Power Tool does not start?
- S
  Scott PatrickAug 12, 2025
  If your Silverline Power Tool doesn't start, first check the power supply and ensure the plug is switched on. It could be due to an interruption in the power supply. If the power cable or mains plug is defective, have it replaced by an authorized Silverline service center. Also, the on/off trigger switch might be defective, requiring replacement by a service center. If you are using a construction site generator, make sure it is active and providing the correct voltage compatible with the machine.
L
lisa72Aug 18, 2025
Why does my Silverline Power Tool not operate at full power?
- G
  gsmithAug 18, 2025
  If your Silverline Power Tool doesn't operate at full power, the extension lead might be too long or inadequate. Try using a suitable extension lead. Also, the voltage provided by the power supply may be too low; check the power supply and switch to a different circuit if possible. If these steps don't resolve the issue, there may be a fault in the machine, and it should be repaired by an authorized Silverline service center.
J
Jennifer CampbellAug 26, 2025
What to do if my Silverline Power Tool has no hammering action?
- H
  Hector GoodmanAug 27, 2025
  If your Silverline Power Tool has no hammering action, it could be because the machine is too cold. Allow the machine to warm up, then run it under no load to warm up the oil and loosen the internal mechanisms. Insufficient lubrication could also be the cause; check the oil level and top it up if needed. Be aware that running the tool with insufficient lubrication may have caused damage, requiring repair by an authorized Silverline service center. A fault may have occurred in the machine, in which case it should be repaired by an authorised Silverline service centre.
L
luiswallerSep 3, 2025
Why is oil leaking from my Silverline 1500W Electric Breaker?
- A
  Antonio JacksonSep 3, 2025
  If oil is leaking from the machine housing of your Silverline Power Tool, it could be due to missing or damaged seals. If this occurs after an oil service or top-up, check the seals underneath the covers that were removed during service. Otherwise, have the tool repaired by an authorized Silverline service center.

Silverline 1500W Electric Breaker Specifications

General

Power	1500W
Voltage	230V
Impact Rate	1900 bpm
Tool Type	Electric Breaker
Frequency	50 Hz

Related product manuals

Preview: Silverline 633567

Silverline 633567

Preview: Silverline 962219

Silverline 962219

Preview: Silverline SILVER STORM Series

Silverline SILVER STORM Series

Preview: Silverline 463429

Silverline 463429

Preview: Silverline 917270

Silverline 917270

Preview: Silverline 675078

Silverline 675078