Silverline 633629 - User Manual

Other manuals for Silverline 633629

Owner's Manual44 pages

Questions and Answers

C
Crystal RodriguezJul 27, 2025
Why is material not blasting from my Silverline 633629 Power Tool?
- R
  Robert PhillipsJul 27, 2025
  If the material is not blasting from your Silverline Power Tool, it could be due to several reasons. First, ensure that you set the correct air pressure according to the specifications. Another reason may be that the material hose is clogged, in this case, remove the rubber hose and clear any blockages. Check your air supply for blockages, and if necessary, disassemble and clean the sandblasting gun. Finally, the abrasive might be incompatible (too coarse or too heavy), so choose a suitable abrasive.
K
Kenneth BushAug 6, 2025
What to do if my Silverline 633629 gun is clogged?
- W
  williamskimAug 6, 2025
  If your Silverline Power Tool gun is clogged, it may be caused by damp abrasive. Replace it with dry abrasive; note that damp material can be dried and reused. Another possible cause is water in the air supply, so check the compressor and filtration system. Lastly, the abrasive might be incompatible (too coarse or too heavy), so choose a suitable abrasive.
A
April HicksAug 15, 2025
How to fix sputtering in Silverline 633629 Power Tool?
- C
  Chad SmithAug 15, 2025
  Sputtering in your Silverline Power Tool can occur due to a worn nozzle. Replace the nozzle to solve this. Another possible cause is abrasive build-up around the nozzle; remove the nozzle and clean it. An air leak can also cause sputtering, so check all fittings and the hose for air leaks, and correct the issue by re-tightening, using PTFE tape, or replacing the faulty components.