Silverline 633629 - Troubleshooting; Material Not Blasting from Gun; Clogged Gun; Sputtering

EN
12
Problem Possible Cause Solution
Material not blasting from gun
Pressure incorrect Setthecorrectairpressureaccordingtothe‘Specications’
Material hose clogged Remove Rubber Hose (6) and remove blockages
Air blockage Check air supply; disassemble and clean sandblasting gun if necessary
Incompatible abrasive
(too coarse or too heavy)
Choose suitable abrasive
Clogged gun
Damp abrasive Replace with dry abrasive (damp material can be dried and reused)
Water in air supply Checkcompressorandltrationsystem
Incompatible abrasive
(too coarse or too heavy)
Choose suitable abrasive
Sputtering
Worn nozzle Replace nozzle
Abrasive build-up around nozzle Remove nozzle and clean
Air leak
Checkallttingsandhoseforairleaksandcorrectissuebyre-
tightening,usingPTFEtapeorreplacing
Tool will not stop after Trigger (4)
is fully released
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
633629_OwnerManual.indd 12633629_OwnerManual.indd 12 07/02/2024 10:5007/02/2024 10:50