Silverline 633629 - Page 11

Air Sandblasting Kit
11
silverlinetools.com
Replacing the Outlet Nozzle
1. Disconnect the sandblasting gun from the air supply
2. Disconnect the Rubber Hose (6) from the sandblasting gun
3. RemovetheNozzleLockingRing(2)andOutletNozzle(1)
4. Clean all threads and sealing surfaces
5. InstallanewOutletNozzle,rettheNozzleLockingRingandtightensecurely
Lubrication
• Even though the air and material passages of the spray gun must remain free of oil and other
contaminants, some components require frequent lubrication
• Slightly lubricate all sealing surfaces, packings, bearings and dynamic O-rings with a specialised
spray gun lube, and apply a small amount of petroleum jelly to springs
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Contact
Fortechnicalorrepairserviceadvice,pleasecontactthehelplineon(+44)1935382222
Web: www.silverlinetools.com
UK Address:
ToolstreamLtd.
Boundary Way
LuftonTradingEstate
Yeovil,Somerset
BA228HZ,UnitedKingdom
EU Address:
Toolstream B.V.
Hogeweg 39
5301LJZaltbommel
The Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of power
tools
• Surplus abrasive may be contaminated with the material it was used to remove. Recycle or
dispose of accordingly
633629_OwnerManual.indd 11633629_OwnerManual.indd 11 07/02/2024 10:5007/02/2024 10:50