What to do if my Silverline Power Tool has no function when the On/Off Rocker Switch is operated?
If the Silverline Power Tool isn't functioning when you operate the On/Off Rocker Switch, first check the power supply. If the power supply is fine, the On/Off Rocker Switch may be defective and must be replaced by an authorised Silverline service centre.
Why does the belt slide off the File Arm (8) of my Silverline Power Tool when turning?
If the belt slides off the File Arm of your Silverline Power Tool when turning, it might be due to incorrect installation. Refer to the instructions on ‘Fitting a sanding belt’. Another reason is a worn, defective, or wrongly dimensioned sanding belt. Try fitting a new sanding belt.
How to improve slow material removal with Silverline Power Tool?
If your Silverline Power Tool is removing material slowly, it might be because the sanding belt is too fine or worn. Try fitting a new sanding belt with a coarser grit.
What to do if my Silverline Power Tool leaves scratches on workpiece after sanding?
If you notice scratches on your workpiece after sanding with the Silverline Power Tool, it could be due to a sanding belt that's too coarse. Try fitting a new sanding belt with a finer grit. It's also possible that not enough material has been removed yet, so continue sanding.
Advises wearing ear protection and limiting exposure to noise and vibration.
States the appliance is not for reduced capability persons unless supervised.
Guidelines for maintaining a safe and clean work environment.
Identifies common problems, causes, and solutions for the tool.
Information on product registration, terms, conditions, and coverage.
Weight and Dimensions| Weight | 1150 g |
|---|
To Next Page
