4
Voltage......................................................220-240V~50Hz
Power................................................................ 110W
No load speed..................................................... 3100min
-1
Pad diameter.........................................................240mm
Ingress protection........................................................IP20
Electrical class ............................................................
Dimensions (L x W x H) .....................................270 x 260 x 215mm
Weight: .............................................................. 2.1Kg
products may alter without notice.
PA
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60dB(A)
WA
......................................................71dB(A)
Uncertainty K............................................................3dB
Weighted vibration a
h
................................................11.5m/s
2
Uncertainty K.........................................................1.5m/s
2
The sound intensity level for the operator may exceed 85dB(A)
and sound protection measures are necessary.
Technical Abbreviations Key
Specication
WARNING: Always wear ear protection where the sound level exceeds 85dB(A) and limit the time
of exposure if necessary. If sound levels are uncomfortable, even with ear protection, stop using the
sound attenuation for the level of sound produced by your tool.
WARNING: User exposure to tool vibration can result in loss of sense of touch, numbness, tingling
and reduced ability to grip. Long-term exposure can lead to a chronic condition. If necessary, limit
the length of time exposed to vibration and use anti-vibration gloves. Do not operate the tool with
hands below a normal comfortable temperature, as vibration will have a greater effect. Use the
of operating the tool.
incorrectly assembled, or misused tool, may produce increased levels of noise and vibration.
www.osha.europa.eu provides information on sound and vibration levels in the workplace that
may be useful to domestic users who use tools for long periods of time.
Description of Symbols
The rating plate on your tool may show symbols. These represent important information about the
product or instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Wear head protection.
Wear hand protection.
Read instruction manual.
Toxic fumes or gases!
Class II construction (double insulated for additional protection)
Environmental Protection
Waste electrical products should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authority or retailer for recycling
advice.
Conforms to relevant legislation and safety standards.
Caution!
V Volts
~, AC Alternating current
A, mA Ampere, milli-Amp
n
0
No load speed
n Rated speed
opm Orbits or oscillations per minute
Ø Diameter
Hz Hertz
W, kW Watt, kilowatt
/min or min
-1
Operations per minute
rpm Revolutions per minute
dB(A) Decibel sound level (A weighted)
m/s
2
magnitude)
Introduction
you are familiar with similar products, it is necessary to read this manual carefully to ensure
you fully understand the instructions. Ensure all users of the tool read and fully understand
this manual.
Original Instructions
261362_Manual.indd 4 07/12/2017 12:41
To Next Page
Loading...
