Silverline 580430 - Troubleshooting; Tool operating slowly; Tool seized; Strong vibrations when tool is switched on

8
GB
Problem Possible Cause Solution
Tool operating slowly
Pressure incorrect Set the correct air pressure according to the specification
Dirt within the mechanism Pour oil into air inlet as per maintenance instructions
Air blockage Operate tool in short bursts to clear blockage
Air leak
Check all fittings and hose for air leaks and correct issue by
re-tightening, using PTFE tape or replacing
Blockage in gauze mesh filter Remove Quick Connector and clean mesh filter
Tool seized
Dirt or rust in mechanism Try ‘Tool operating slowly’ solutions
Dirt or rust in mechanism Tap tool gently with a soft mallet
Dirt or rust in mechanism
Free mechanism by rotating drive manually when disconnected
from air line
Strong vibrations when tool is
switched on
Sanding disc incorrectly attached or damaged Reattach or replace sanding disc
Backing pad damaged Replace backing pad
Spindle bent Have the tool repaired by an authorised Silverline service centre
Tool will not stop after trigger
is fully released
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
580430_Z1MANPRO1.indd 8 29/10/2013 12:26