59
Bow Thruster
You may have chosen as an option when
you purchased your 352 MY, a Bow Thrust-
er System. The purpose of this system is
to aid in maneuvering your yacht in close
quarters, such as departing or entering a
marina boat slip. The Bow Thruster propels
the bow of your yacht in a Port or Starboard
direction, depending on your selection,
which is made from a control panel located
at the helm station (See photograph below,
which illustrates the Bow Thruster Control
Panel). The Bow Thruster operates on DC
electrical power, controlled by a breaker
switch, located on the Bilge DC electrical
panel .
REFER TO THE BOW THRUSTER MAN-
UAL INCLUDED WITH YOUR OWNER’S
PACKET FOR ADDITIONAL TECHNICAL
INFORMATION CONCERNING THE OP-
ERATION AND MAINTENANCE OF THIS
OPTIONAL SYSTEM.
Check the transmission fl uid level. The
engines should be running at idle speed
and at normal operating temperature.
The transmission fl uid should read FULL
on the “dipstick”. If the fl uid level is low,
add suffi cient transmission fl uid to raise
the level to the FULL mark or slightly
lower. DO NOT overfi ll. If the fl uid level
is low, check the transmission(s) for
leaks and contact your Silverton dealer
for repairs if leaks are noted.
REFER TO THE ENGINE MANUAL IN-
CLUDED WITH YOUR OWNER’S PACKET
FOR ADDITIONAL TECHNICAL INFOR-
MATION CONCERNING MAINTENANCE
REQUIREMENTS FOR THE SPECIFIC
ENGINES WITH WHICH YOUR 352
YACHT IS EQUIPPED.
•
To Next Page
Loading...