2
Engine Seawater Pickup
The photograph below displays the Engine
Seawater Pickup as shown on the Star-
board side. The Engine Seawater Pickups
are located on the bottom exterior of the
hull forward of the engines and are used
for “scooping” water for the engine cooling
system.
Transom Anode Plate
The photograph below displays the Tran-
som Anode Plate, which is a sacrifi cial
zinc anode that is bolted to the transom and
connected to the electrical bonding system.
Its purpose is to prevent electrolysis and
galvanic corrosion of the underwater com-
ponents in your yacht, which is discussed
in the Bonding System Section of this
Owner’s Manual.
Trim Tabs
The photographs below display the Port
and Starboard Trim Tabs, which are factory
installed on the lower edge of the transom.
The purpose of the Trim Tabs is to assist
you in controlling the angle, both longitudi-
nally and athwartships, that your yacht rides
in the water during forward movement. The
control panel for the Trim Tabs is located at
the helm station.
To Next Page
Loading...