6
Warning Horns
The factory installed Warning Horns are
mounted on the forward section of the
bridge. The horns are self contained units
operating on 12 v power supplied from the
electrical system. The switch for the horns is
located on the console (see console layout
on page 147).
Bilge Ventilation Intake
and Exhaust Vents
The Bilge Ventilation Air Intake Vent is
located on the outboard side panel of the
Port bridge-to-bow access steps. The Bilge
Ventilation Air Exhaust Vent is located on
the outboard side panel of the Starboard
bridge-to-bow access steps. The purpose
of these vents is for ventilation of the en-
gine and generator compartments, which is
discussed in the Bilge Ventilation System
Section of this Owner’s Manual. Be certain
to read and have a thorough understanding
of this section. It contains important infor-
mation concerning the SAFE operation of
your yacht. The photograph below displays
the Bilge Ventilation Air Exhaust Vent. The
Bilge Ventilation Air Intake Vent is identical
in appearance.
To Next Page
Loading...