49
rocker-type switch to control the rinse water
level and the volume is consistent (approxi-
mately 1 - 2 quarts per fl ush). As with the
fresh water system, to prevent contamina-
tion of the raw water supply, this system is
equipped with an anti-siphon breaker con-
tained in the water control solenoid valve.
The water control solenoid valve of each
toilet is controlled by an electrical breaker
switch, located on the AC/DC Electrical
Panel (See AC/DC Electrical Panel Layout
on Page 159, which illustrates the location
of the breaker switches). Toilet waste, both
liquid and solid, is fl ushed from the toilet by
the macerator to a Waste Tank having a
capacity of sixty (60) gallons (See Mechani-
cal Layout on Page 151 and 152, which
illustrates the location of the Waste Tank).
This waste is stored in the Waste Tank until
pumped out at a proper facility. The Waste
Tank is equipped with an electronic Waste
Level Gauge, which monitors the volume
of waste in the tank for your convenience
in determining when pump-out is required
(See photograph on previous page, which
illustrates the location of the Waste Level
Gauge).
Maintenance of your Jabsco Quiet-Flush
Electric Toilet Sanitation System consists
of periodic cleaning of the toilet bowl with
a mild nonabrasive cleaner. The Waste
Tank should be thoroughly rinsed after each
pump-out and a sanitation system deodor-
izer should be added to the Waste Tank by
fl ushing through the toilet.
DO NOT use chlorine-
based or caustic cleaning agents or
chemicals, such as drain opening prod-
ucts, in your Jabsco Quiet-Flush Sanita-
tion System. Use of these products may
cause serious damage to the system’s
seals and hoses.
REFER TO THE JABSCO QUIET-FLUSH
TOILET MANUAL INCLUDED WITH YOUR
OWNER’S PACKET FOR ADDITIONAL
TECHNICAL INFORMATION CONCERN-
ING THE USE AND MAINTENANCE OF
BOTH THE FRESH WATER AND RAW
WATER SYSTEMS.
REFER TO THE WINTERIZATION AND
STORAGE SECTION OF THIS OWNER’S
MANUAL FOR THE PROPER PREPARA-
TION PROCEDURE FOR EXTENDED
STORAGE IN COLD CLIMATES.