SIMAG SVD 152 - FOR THE ELECTRICIAN; ELECTRICAL CONNECTIONS

15

FOR THE ELECTRICIAN
ELECTRICAL CONNECTIONS
The unit comes equipped with an electrical cord
for power supply. The lead wires must be
connected to an electrical plug that
corresponds to the local electrical codes and
requirements or to a separate two poles
disconnect box with opening to the contacts of
about 3 millimeters. The disconnect box should
be placed close to the selected ice maker
location to be easily and prompt reached.
Undersized wiring or improperly installed
electrical circuit will result in major problems
and malfunctions. Voltage variations should not
exceed ten percent.
IMPORTANT - All plumbing and
electrical connections must be made by
licensed plumbers and electricians, this
one must follow the electrical
specifications printed on the ice maker
nameplate.
NOTE:
All SIMAG Cubers require a neutral wire and
a solid earth ground wire to prevent possible
severe Electrical Shock Injury to individuals
or extensive damage to equipments.