www.ssimder.com
Unpacking
Check the packaging for any signs of damage.
Carefully remove the machine and retain the packaging until the installation is complete.
Location
The machine should be located in a suitable position and environment. Care should be taken to
avoid moisture, dust, steam, oil or corrosive gases.
Place on a secure level surface and ensure that there is adequate clearance around the machine
to ensure natural airflow.
Input connection
Before connecting the machine you should ensure that the correct power supply is available.
Details of the machine requirements can be found on the data plate of the machine or in the
technical parameters shown in the manual.
The equipment should be connected by a suitably qualified competent person. Always
ensure the ground clamp is properly connected before using.
Never connect the machine to the mains supply if the panels were removed.
Output connections
In general when using ARC welding mode, the electrode holder should be connected the positive
Terminal, the ground clamp to the negative terminal and clamp to the work-piece.
When using MIG welding mode, the ground clamp should be connected to the positive terminal
and and clamp to the work-piece.
To Next Page
Loading...