Sime FORMAT DGT HE User Manual

1.12 INSTRUCTIONS FOR
OPTIONAL PROGRAMMING
CLOCK (fig. 14)
Setting the time
The time of day can be set by grasping
the outer edge of the black dial and
turning it in a clockwise direction until
the correct time is in line with the white
pointer.
Setting the “switching time”
The “ON” periods are set by sliding the
blue tappets, adjacent to the time periods
required, to the outer edge of the dial.
The tappets that remain at the centre
of the dial will be the “OFF” periods.
N.B.: The smallest switching time (ON
or OFF) is 15 minutes.
– To select “Timed” mode move the
selector switch in the middle of the
clock face to the “”position (mid-
dle of the slot).
– To select “Constant” mode move
the selector switch in the middle of
the clock face to the “I” position
(bottom of the slot).
– To select “OFF” mode move the
selector switch in the middle of the
clock face to the “O” position (top of
the slot).
10
Fig. 11
D
r
F
(O)
I
O
Slide blue tappets
OUT for ON period
Slide blue tappets IN for OFF period
Mode selector switch
Slide black tap-
pets OUT
= ON period
Slide black tappets IN = OFF period
Heating OFF (O)
Heating
PROGRAMMIED
Heating ON (I)

Sime FORMAT DGT HE Specifications

General

Brand	Sime
Model	FORMAT DGT HE
Category	Boiler
Language	English