SRM9030plus ~ PMR Mobile Radio User Guide
© Comgroup Australia 2010 28 TNM-U-E-0092 Issue 1.1a
7.11 G
O TO
C
HAN
A, B, C, D
Selects predefined Channel A, B, C or D, and returns on the second press.
The Defined Channel is redefined if held for approximately 2 seconds.
7.12 S
PECIAL
E
NC
1…8
Sends Special Encode 1, 2, … 8.
7.13 A
LARM
Put the mobile into Alarm mode.
7.14 R
EPEATER
D
EFEAT
Allows the radio to transmit on the reverse frequency on a Repeater Channel.
When the button is pressed again (or the Channel is changed) the transmit frequency reverts
to the original setting.
7.15 L
OW
P
OWER
Forces the radio to low power.
Pressing again puts the radio back to the power level defined for the current channel. This is
not affected by Channel changes.
7.16 H
ANDSFREE
(VOX)
Toggles the VOX function for the Handsfree Microphone.
7.17 DTMF M
ODE
This function places the numeric keypad into DTMF mode, refer to Section 5.7.
7.18 S
CRAMBLER
O
N
/O
FF
If enabled by the Field Programmer, this function toggles the state of the speech scrambler.
When active, there will be a short audible tone at the start of PTT to inform the user of the
scrambler activation. Each time the key is pressed, the display will show “On” and “Off”.
To Next Page
Loading...
