SCRUBBING & CLEANING
The Polisher/Sander is also equipped
with a scrubbing brush. The brush is ideal
for light cleaning applications such as tile
and other non-porous surfaces.
NOTE: Because of the random orbit
action, the scrub brush will NOT work on
carpets.
WARNING: Never use volatile
fluids such as gasoline. These can
cause an explosion and fire and
seriously injure you.
WARNING: Never submerge the
tool or the scrubbing brush directly
into water or other cleaning solutions.
Spray the surface with the cleaning
solution.
Install the scrubbing brush on the hook
surface of the mounting plate (see Fig.
10).
WARNING: Never allow brake
fluids, gasoline, petroleum based
products, penetrating oils or other such
products to come in contact with plastic
parts. They contain chemicals that can
damage, weaken and destroy plastic.
CLEANING THE SANDER/POLISHER
Clean the exterior of the tool with a soft
damp cloth. NEVER use commercial
solvents when cleaning the tool because
they can cause damage to plastic parts.
WARNING: Never immerse the
tool in water. Remove the foam pads
and clean them separately.
CARE OF ACCESSORIES
The foam and microfibre pads are
washable and reusable. Simply remove
them from the tool and wash them in
warm water with a mild detergent. Rinse
thoroughly in clear warm water.
NOTE: Allow pads to air dry. Do not force
dry them in a clothes dryer. The dryer will
damage the pad material.
When storing the tool, remove the foam
pads to prevent compression and
distortion of the foam.
SERVICING
WARNING: Always remove the
battery from the tool while before
performing any servicing.
REPLACING MOUNTING BASE
It may be necessary to replace the
mounting base due to continual exposure
to dust and debris. The following
procedure will demonstrate how to
remove the mounting base from the tool.
1. Remove accessory pad or sanding
disc from the base.
2. Insert a (#1 or #2) Phillips
®
screwdriver through the hole (1) in
the bottom of the base (see Fig. 11).
To Next Page
Loading...
